Now you're ready for step
Mounting a projector screen without drilling is easy. You may have a lot of work to do, but you can do it without drilling. With these simple steps, you'll have the screen mounted in no time.
Image source: https://www.homedepot.com/
Step 1: Find the best location for mounting the screen. The easiest way to find the best location is by looking at where someone would be sitting when they are in front of it.
Image source: https://www.croma.com/
You want them to have an unobstructed view of what's on your screen, so you need to make sure that you're not blocking their line of sight.
Image source: https://www.dell.com/
If they are sitting directly in front of the screen, you'll want to make sure that nothing is behind them or anything is distracting their sight line before mounting it on a wall.
Image source: https://na.panasonic.com/
Step 2: Mark the two holes for screws with a pencil. (Note: the hole locations may be different from what you see in the image above.)
Image source: https://na.panasonic.com/
You need to use pilot holes for mounting to wood, so make sure that you start out with holes that are about 1/4 inch smaller than the proper size of your drill bit.
Image source: https://epson.com/
The screws will go in these holes. If you have any questions as to where to put them, ask your friends or family members who have a lot of experience with mounting things on walls and they'll be happy to help. Step 3:
Measure and mark the wall where you're going to mount it. The screen should be mounted on a wall that is at least 32 inches high, but anything higher will help keep it propped up and ready for use.
Image source: https://protechprojection.com/
If it's mounted too low, it will block the view and make it hard to use. Step 4: Put together the necessary tools.
Image source: https://pro.sony/
You'll need some type of saw like a miter saw or jigsaw with a track. You'll also need a drill and drill bits, a level, and any other tools and materials you might need. Step 5:
Image source: https://www.amazon.com/
Cut the film to size with a piece of film that is roughly two feet long. Bend the ends over each other so that they form an "X."
Image source: https://www.lg.com/
Then cut both ends off with scissors so that now you have two pieces of film that are about 6 inches long.
Image source: https://justinrange.com/
Step 6: Slide the film into the channel, then lay the channel over the hole you marked. Make sure that it's smooth on both sides. Step 7: Hold a sheet of paper up close to the screen and move it from left to right.
Image source: https://www.homedepot.com/
If you can see light coming through from behind, then you'll need to use tape or some other method to seal off those light leaks. Step 8: Seal off all of your light leaks with tape. You should now be able to see that there is no more light leaking through anywhere like you saw in step 7.
Image source: https://www.dell.com/
Step 9: Insert wood screws into the pilot holes punctured into the screen. Step 10: Make sure that the screen is in place and the screws are tightened. Make sure that it is level, then make any necessary adjustments before moving onto step 11. Step 11: Drill holes from the other side of the wall for your wires to pass through into the channel that you made for them in step 6, then run your wires through these holes.
Image source: https://epson.com/
Comments
Post a Comment